Using oil treated dust mop.

Not dust mopping often enough.

Not removing spillage when it occurs.

Use dust mop treated with water based ZING Dust Control.

Treat dust mop with ZING Dust Control & mop 1 or 2 times daily.

Remove all spillage using a clean damp mop & ZING Nutra Clean. Wring mop dry. Do not leave excess water behind.

Finish of ZING Floor Coating applied to an uncured surface.

Using an incorrect burnishing pad.

Using hot water when mopping.

Not enough finish or ZING Floor Coating.

Using a low-shine finish.

Allow a minimum of 20-30 minutes drying time between coats. Allow 24 hours for curing, before burnishing.

Use the ZING Time-Saver Hair Pad for all burnishing.

Use cold water only.

Using a permanent marking pen, place a "1", "2", "3" etc., to indicate the number of each coat, on top of each coat, after it dries. Recoat the traffic area, whenever a number disappears.

Using too much ZING CPC.

Occurs the first day after applying ZING Floor Coating + Plus.

Using a buffable finish or ZING Floor Coating.

Use a 3" ribbon of ZING CPC to burnish 1000 sq. ft. (more is not better).

After burnishing the first time, 50% - 60% less scuffing will occur.

Increase burnishing frequency.

Using spray buffing.

Using restoration products.

Using an improper finish or ZING Floor Coating for the amount of traffic present.

Stop spray buffing & use ZING CPC.

Stop using restoration products & use ZING CPC.

Use Zing Floor Coating for periodic maintenance & ZING Floor Coating + Plus for routine maintenance.

Not dust mopping often enough.

Not cleaning dust mop when filled with dust & dirt.

Treat dust mop with ZING Dust Control & mop 1 or 2 times daily.

Clean dust mop with center of stripping pad by rubbing top to bottom. Retreat.